Bunn COMBO BREWER Instructions d'exploitation télécharger pdf (Page 4)

INITIAL SET-UP (cont)

Brewer (cont.)

13. Place an empty decanter on the warmer, place the On/Off switch in the lighted “ON” position, remove and reinsert

the empty brew funnel, and momentarily press the start switch. At the completion of this cycle, place the On/Off

switch in the “OFF” position, and carefully measure the total water in the decanter. It should be 64 ounces.

14. If not, disconnect the Combo

from the power source, and adjust the desired brew volume. (Refer to the adjustment

section.)

15. Repeat steps 12 - 14 until the proper total water volume is achieved. Then proceed to the grinder section, below.

Grinder

1. Place some whole bean coffee in each of the two hoppers.

2. Place the Hopper Select switch on the grinder in the “RIGHT” position.

3. Place the Selector switch (center) in the upper “GRIND/BREW” position.

4. Place a BUNN

paper filter in an empty brew funnel.

5. Place the On/Off switch in the lighted “ON” position, insert the brew funnel, and momentarily press the start switch.

Immediately after the grinder motor stops, remove the brew funnel and carefully weigh the filter and ground coffee.

6. If the weight of the coffee is satisfactory, proceed to step # 9 below.

7 If not, disconnect the Combo

from the power source, and adjust the desired grind volume. (Refer to the

adjustment section.)

8. Repeat steps 4 - 7 until the desired grind volume is achieved from this hopper.

9. Place the Hopper Select switch on the grinder in the “LEFT” position.

10. Place a BUNN

paper filter in an empty brew funnel.

11. Place the On/Off switch in the lighted “ON” position, insert the brew funnel, and momentarily press the start switch.

Immediately after the grinder motor stops, remove the brew funnel and carefully weigh the filter and ground coffee.

12. If the weight of the coffee is satisfactory, proceed to step # 15 below.

13 If not, disconnect the Combo

from the power source, and adjust the desired grind volume. (Refer to the

adjustment section.)

14 Repeat steps 10 - 13 until the desired grind volume is achieved from this hopper.

15. The Combo

is now ready to grind and brew a batch of fresh coffee.

OPERATING CONTROLS

A. Lighted On/Off Warmer Switch (Left Switch above the brew funnel)

ON - Placing the switch in the lighted upper position allows the start switch to activate a grind & brew or brew cycle.

This position also energizes the brew station warmer.

OFF - Placing the switch in the lower position stops the cycle and shuts-off power to the brew station warmer. Stopping

a brew cycle after it has been started will not stop the flow of water into the funnel until the tank syphons down to its

proper level.

NOTE - The switch should always be placed in the “OFF” position after a cycle and whenever the Combo

is unattended.

B. Grind/Brew & Brew Only Selector Switch (Center Switch above the brew funnel)

Grind/Brew - Placing the switch in the upper position instructs the Combo

to grind a preselected amount of coffee

into the brew funnel and immediately brew into the funnel when a cycle is properly initiated.

Brew Only- Placing the switch in the lower position instructs the Combo

to skip the grind cycle and immediately brew

a batch of coffee when a cycle is properly initiated.

C. Start Switch

Starts the selected type of brew cycle when the lighted On/Off Warmer switch is in the “ON” position.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Bunn COMBO BREWER Instructions d'exploitation Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Bunn COMBO BREWER