4
INITIAL SET-UP
CAUTION - Unplug the grinder throughout the initial set-up.
1. Open the top lid. Clear all foreign objects and shipping materials from the hopper compartment and the
entrance to the grind chamber.
2. Install filler plate.
3. The grinder can now be plugged-in and put into service.
OPERATING CONTROLS
Grind Selector
Allows the user to vary the grind for each coffee. Each setting will provide precisely the same grind every time
it is selected.
Off/On/Start Switch
OFF/STOP - (upper position) Switching to this position stops the operation of the grinder.
ON - (center, resting position) The switch will return to this position after a grind cycle has begun and will
remain in this position after grinding has ceased.
START - (lower, momentary position) Pressing the switch initiates grinding only when a bag is in place
behind the chute or the brew cup is in place.
Bag/Brew Cup Sensor
Prevents the grinder from operating unless the back of a bag is in place behind the dispense chute or the brew
cup is not in place. Do not attempt to bypass this safety device.
Cleaning Lever
Allows the operator to clean out any coffee residue left from the previous grind.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specied in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of
this appliance by a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with
a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
• Machine must not be immersed for cleaning.
• Machine rated IXP1.
43254 021712
ELECTRICAL REQUIREMENTS
CAUTION - The grinder must be disconnected from the power source until specified in Initial Set-Up.
Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements.
100V & 120V
Models
230 VOLT CE Model
Note: This electrical service consists of 2 current carrying conductors (L1 and Neutral) and a separate conductor
for chassis ground.
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels