Bunn Axiom Series Manuel de service télécharger pdf (Page 8)

Page 8

CLEANING

1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for

cleaning all surfaces on Bunn-O-Matic equipment.

2. Check and clean the sprayhead. The sprayhead holes must always remain open. Insert the short

end of the sprayhead cleaning tool into each of the ﬁve water outlets of the plastic sprayhead to

remove any mineral deposits (Refer to Fig 1)

3. Insert the long end of sprayhead cleaning tool into the sprayhead ﬁtting, and rotate several times

to remove any mineral deposits from the ﬁtting (Refer to Fig 2).

NOTE: In hard water areas, this may need to be done daily. It will help prevent liming problems in

the brewer and takes less than a minute.

NOTE: In the event that the "Brew Logic" circuit activates (compensating for high lime build up), it

will temporarily disable the "Recovery Booster" and "Pulse Brewing" systems until the unit has been

de-limed. Refer to the Troubleshooting section for more details.

FIGURE 1 FIGURE 2

39130 060206

TANK DRAIN

1. Loosen screws that secure the front access panel. Remove the panel.

2. Unfasten the hose clamp at the end of the drain hose. Remove the plug.

3. Place the end of the drain hose in a container that has a minimum capacity of 200 oz (5.9 L).

4. Release the white clamp to drain water from the tank.

5. When tank is empty, close the white clamp, replace the plug, and tighten the clamp at the end

of the drain hose. (Repeat steps 2-5 for remaining side on Twins)

6. Replace the front panel and tighten screws.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Bunn Axiom Series Manuel de service Page 8