Bunn FMD-2 Manuel de service télécharger pdf (Page 19)

SERVICE (cont.)

3. Press and hold the appropriate dispense switch

and check the voltage across the disconnected

harness wires with a voltmeter. Connect the dis-

penser to the power source. The reading must

be:

a) 120 volts ac for two wire 120 volt models.

b) 120 volts ac for three wire 120/208 volt or 120/

240 volt models.

c) 240 volts ac for two wire 240 volt models.

4. Disconnect the dispenser from the power source.

If voltage is present as described, replace the motor.

If voltage is not present as described, refer to the wir-

ing diagrams and check the dispenser wiring harness.

BLK from Control Harness

WHI from Control Harness

FIG. 11 FAN TERMINALS

P1507

6. Reconnect the vacuum hose to the fan.

FAN (cont.)

FROTHER AND WHIPPER MOTOR

FIG. 11 FROTHER AND WHIPPER MOTOR

P1450.40

Location:

The frothers are located behind the dispenser

door, mounted on the whipper motor shaft inside the

whipper chamber.

The whipper motors are located on the back side of

the whipper motor mounting panel.

NOTE: The center position is for FMD-3 Models only.

Test Procedure:

1. Disconnect the dispenser from the power source.

2. Disconnect the white/violet and white wires on

the right motor, orange and white wires on the

center motor or the red and white wires on the

left motor from the black leads on the motors.

10 9 8 7 6 5 4 3

FIG. 12 MIXING/WHIPPER CHAMBER

COMPONENTS

P1440.35

1. Steam Collector

2. Mixing Chamber

3. Dispense Tip

4. Whipper Chamber

5. O-Ring

6. Frother

7. #6-32 Screw

8. Receptical w/Seal

9. Teflon Washer

10. O-Ring

11. #8-32 Acorn Nut

12. Motor Assy.

13. Washer

14. Nut

15. Fan

16. Vacuum Hose

17. Baffle

15 16 17

1 2

28364 071598

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Bunn FMD-2 Manuel de service Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Distributeurs d'eau Bunn FMD-2