Bunn CRTF5 Manuel d'utilisateur télécharger pdf (Page 19)

Page 19

SERVICE (cont.)

START SWITCH

Location:

On brewers w/out fresh light the start switch is

located in the right front of the hood.

On brewers w/fresh light the start switch is located

on the right side of the hood.

Test Procedure:

1. Disconnect the brewer from the power supply.

2. Disconnect the blue wire and the white/red wire

from the switch terminals.

3. Check for continuity across the two terminals on

the switch when it is held in the "pressed-in"

position. Continuity must not be present across

these terminals in the released position.

If continuity is present as described, reconnect the

blue wire and the white/red to the switch terminals.

If continuity is not present as described, replace the

switch.

Removal and Replacement:

1. Remove the blue wire and white/red from the start

switch.

2. Remove round retaining nut from the front of the

switch and remove switch and internal tooth

lockwasher from the inside of the hood.

3. Push new switch with internal tooth lockwasher

through the hole in the hood and secure with round

retaining nut.

4. Refer to Fig. 11 when reconnecting the wires.

BREWERS W/FRESH LIGHT

P1258.50

FIG. 10 START SWITCH

P939

FIG. 11 START SWITCH TERMINALS

P1259

10478 061500

BLU to Timer P1

WHI/RED to

Timer P3

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Bunn CRTF5 Manuel d'utilisateur Page 19