Bunn FMD-2 Manuel de service télécharger pdf (Page 28)

SERVICE (cont.)

RINSE /RUN SWITCH

FIG. 24 RINSE/RUN SWITCH

P1452.40

Location:

The rinse/run switch is located on the right

side of the whipper motor mounting panel.

Test Procedures:

1. Disconnect the dispenser from the power source.

2. Check for continuity between center terminal and

the upper terminal with the switch in the “RUN”

lower position. Continuity must not be present

with the switch in the “RINSE” upper position.

If continuity is present as described, the switch is

operating properly.

If continuity is not present as described, replace the

switch.

Removal and Replacement:

1. Open the dispenser door.

2. Remove the facenut securing the run/rinse switch

to the whipper motor mounting panel.

3. Remove switch with wires attached from the back

side of the whipper motor mounting panel.

4. Disconnect the wires from the switch and dis-

card the switch.

5. Refer to Fig. 25 when connecting the wires to

the new switch.

6. Install new switch with wires attached through

the hole in the whipper motor mounting panel

and secure with facenut.

FIG. 25 RINSE/RUN SWITCH TERMINALS

P1456

BLK to Main

Wiring Harness

BLK from

Hopper Delay

Board #4

28364 011598

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Bunn FMD-2 Manuel de service Page 28