Bunn G9-2T DBC Manuel d'utilisateur télécharger pdf (Page 27)

1. Indicator Adjustment Cap & Decal

2. Adjusting Screw

3. Burr Housing Cap

4. Rotor Cup

5. Shear Plate

6. Rotor

7. Spring

8. Burr (Rotating)

9. Burr (Stationary)

P1311

Removal and Replacement - GRIND CHAMBER

1. Refer to the illustration above and remove the two

1/4”-20, hex head screws holding the burr housing

cap(3) to the burr housing; carefully remove the

burr housing cap. Inspect the adjusting screw(2)

to see if the thrust plug is worn.

Replace if excessively worn or damaged.

2. Carefully remove rotor cup(4), shear plate(5), and

burr rotor(6) from the grinder. Inspect the shear

plate and burr(8) for wear.

Replace if excessively worn or damaged.

3. Remove and inspect stationary burr(9) for wear.

Replace if excessively worn or damaged.

NOTE: Burrs must be replaced as a set.

4. Inspect the grind chamber and remove any for-

eign materials. The burrs will not properly seat

in the chamber if any material or coffee particles

remain.

5. Reinstall the stationary burr, spring, burr rotor,

shear plate, rotor cup, and burr housing cap to the

burr housing.

6. Refer to ADJUSTMENTS in the Installation and

Operating Manual to vary the grind dispensed.

SERVICE (Cont.)

MOTOR (Models G9, G9-2, MHG)

FIG. 17 MOTOR AND GRIND CHAMBER

41545 122209

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 78 79

Pas de commentaire

Bunn G9-2T DBC Manuel d'utilisateur Page 27