Bunn G9-2T DBC Manuel d'utilisateur télécharger pdf (Page 5)

41545 111711

Figure 1

Step 1 - Remove & discard tape holding funnel arm in place. (Figure 1)

Step 2 - Remove & discard two silicon tubes between funnel guide &

housing. (Figure 2)

Step 3 - Remove four screws in front housing panel. (Figure 3)

Step 4 - Remove & discard shim under transducer. (Figure 4)

Step 5 - Replace housing panel and secure four screws. (Figure 3)

Figure 3

Figure 2

Figure 4

WARNING

MUST BE COMPLETED BY AUTHORIZED SERVICE PERSONNEL.

DO NOT PLUG IN !

SEE INSTRUCTIONS BELOW BEFORE USING !

G9 WD - Packaging & Shim Removal

1 2 3 4 5 6 7 8 9 10 ... 78 79

Pas de commentaire

Bunn G9-2T DBC Manuel d'utilisateur Page 5