Bunn ULTRA-2 Manuel de service télécharger pdf (Page 25)

OTHER RECOMMENDATIONS FOR YOUR DISPENSER

• Whether liquid concentrate or granulated powder, all product must be thoroughly mixed BEFORE adding it

to the hoppers.

• For best results with granita-type products, use only products with an apparent brix of 12 or higher. Some

products may work with an apparent brix as low as 9. Your experimentation with other products will be the

best guide in this area.

• Keep the pre-mixed liquid product refrigerated. This reduces cooling/freezing time in the dispenser.

• Keep the hoppers topped-off during peak serving periods. Add pre-mixed liquid product as it is dispensed.

This reduces the cooling/freezing time and assures you of always having product ready to dispense.

• Keep the product level in the hoppers higher than the auger. Air will become entrapped in the mixture

resulting in a clouded foamy consistency.

• You may find it beneficial to turn down the ice controls to keep the ice granules from growing too large.

Refer to

Programming The Dispenser

on page 11 for Setting the Consistency.

• Some products freeze at a lower temperature than others. You may notice frost or ice on the hoppers. This

is normal and should not be a concern.

• Humidity in the air may cause sweating on the outside surfaces of the hoppers. This is to be expected and

should not be a concern. The drip trays beneath the hoppers will capture this and cause it to flow to the

lower drip tray for disposal.

• Some noises are to be expected during normal operation of the dispenser. By becoming familiar with the

noises made during normal operation, you will be better able to listen for problems.

32080.0001 021105

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Pas de commentaire

Bunn ULTRA-2 Manuel de service Page 25