Bunn ULTRA-2 Manuel de service télécharger pdf (Page 26)

10. Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow all parts to soak for at least

5 minutes. Carefully wash all components with a clean wash cloth in the hot water and sanitizer solution. Use a

clean, soft bristle brush as needed for the smaller components and tight areas. Do not immerse hopper lids. Use

a commercial sanitizer that has 100 ppm of available chlorine with a concentration level of at least 3% available

chlorine (KAY-5 Sanitizer). Follow the sanitizer’s mixing instructions to ensure 100 ppm of available chlorine.

11. Wash the drums, hopper drip trays, top covers, and outer enclosure using a clean wash cloth that has been

dampened in the hot water and sanitizer solution. Pay particular attention to the shaft area and make sure it

is thoroughly cleaned and sanitized.

12. Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with

a clean dry wash cloth before reassembling the dispenser.

NOTE – Although most parts are dishwasher safe, they may be affected by the chemicals in some commercial

sanitizing agents. Do not place the hopper nor hopper lids in a dishwasher. Rinse thoroughly before assembly.

2. Depress the hopper lock

plunger. Lift the hopper up

slightly.

5. Remove the cooling drum seal

from the rear of the drum.

4. Pull the auger from the cooling

drum.

9. Care must be taken to ensure this surface does not get scratched during

cleaning. Deep scratches could cause leakage around the seal.

7. Carefully slide the faucet valve

up to remove the spring and

faucet seal. Extra care should

be taken when handling the seal

to prevent damage. Do not fold

the seal as this will cause dam-

age to the Teflon

sealing sur-

face.

6. Caution: The faucet valve is

under spring tension. Spread

one side of the handle first, then

the other and disconnect from

the hopper.

8. Remove the auger nose bushing

from inside the hopper.

3. Pull forward to remove.

RECOMMENDED DAILY CLEANING

NOTE – Turn the power OFF to the dispenser before proceeding.

1. Empty all product from the hoppers. Disconnect the hopper lid lamp cords and remove the lids.

32080.0001 021105

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Bunn ULTRA-2 Manuel de service Page 26