Bunn AutoPOD Manuel de réparation télécharger pdf (Page 11)

Page 11

Location:

The Control Board is located inside the back cover.

Test Procedures:

The test procedures for the control board will vary

depending upon the problem. Refer to the Troubleshooting

section which is divided into three sections, Reﬁll Circuit,

Heating Circuit, and Brewing Circuit.

CheckforPowertoboard:

1. Place one meter lead at L1 terminal and the other lead

at L2 terminal.

2. With the power connected to brewer, the voltage read-

ing to the board should be the line voltage rated for that

model.

Ifnovoltageispresent,checkwiringtotheboard.

Ifvoltageispresent,andbrewerdoesnotpower

on,replaceboard.

RemovalandReplacement:

1. Disconnect brewer from power source.

2. Disconnect the cord from L1 & L2 on the control board.

3. Disconnect the connectors from the control board.

4. Remove the 6 screws securing the control board to

the mounting bracket.

5. Install new board with screws removed in # 4.

6. Re-install wires & connectors.

FIG.11-1CONTROLBOARD-AutoPod

CONTROL BOARD

FIG.11-2CONTROLBOARD-MyCaféAP

41169 120711

SW1

PRGM

LOCK

SET

J3 J1

J11

J12

4 3

2 1

1 2 3 4 6 5 4 3 2 1 2 1

2 1

RED (TH4/MOV1)

BRN (TH2/MOV2)

YEL (TH3/MOV3)

TR 1 – Heater Output (Line Voltage)

RED – Solenoid (Line Voltage)

BRN – Solenoid (Line Voltage)

YEL – Rectiﬁed Line Voltage

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

Bunn AutoPOD Manuel de réparation Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Bunn AutoPOD