Bunn AutoPOD Manuel de réparation télécharger pdf (Page 19)

Page 19

Location:

The index motor & sensor are located on the

ejector assembly. FIG 18-1.

Function:

A: Motor drives the pod holder from brew position to

open position to dump position.

B: Photosensor detects position of pod holder by

reading slots in motor disk.

Test Procedures:

1. Go to "TEST INDEX MOTOR" in the "TEST OUTPUTS"

mode.

Press & hold "DUMP" (OPEN/CLOSE button) drives

the pod holder back to the pod ejection position.

Press & hold "LOAD" (HOT WATER button) drives

the pod holder out to the door open position.

• "L" indicates the assembly is in load postion FIG

19-1a/b.

• "B" indicates the assembly is in home postion

FIG 19-2a/b.

• "D" indicates the assembly is in dump postion FIG

19-3a/b.

• "

" indicates the photo sensor is not blocked by

the disk.

• " " indicates the photo sensor is blocked by the disk.

EJECTOR ASSEMBLY

FIG.18-1INDEXMOTOR/SENSOR-MyCaféAP

1. With a voltmeter, check voltage across the terminals

of the motor. Activate motor in the "TEST OUTPUTS"

program mode. The indication must be 12 vdc on

all models. Continuity is not a viable test for this

motor.

CONTINUED

41169 120711

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Bunn AutoPOD Manuel de réparation Page 19