Bunn AutoPOD Manuel de réparation télécharger pdf (Page 9)

Page 9

41169 120711

TROUBLESHOOTING (cont.)

PROBLEM PROBABLE CAUSE REMEDY

MISCELLANEOUS

"INDEX MOTOR FAULT"

CBA has sensed that motor as-

sembly has not rotated timing

disk within 15 seconds.

"REPLACE SEAL SOON/NOW!!!"

Counter set for 25000 brews.

Early models were set at 5000.

"PATH CLEAR?

ANY SWITCH TO CONTINUE"

Formerly "OBSTRUCTION"

Triggered when load on motor ex-

ceeds .1 amp.

Tripping GFCI breaker.

1. Pod(s) binding pod holder as-

sembly.

2. Debris on sensor blocking optical

path.

3. Timing disk coupler loose/slipping.

4. No voltage to motor.

5. Motor defective.

6. Sensor defective.

1. "PM"

1. Pods causing obstruction.

2. Loose Sprayhead/seal

Tank heater defective.

Remove blockage.

Clean.

Tighten. Refer to alignment procedure.

Check wiring/CBA.

Check/replace.

Check/replace.

Replace sprayhead seal and reset

counter.

Clear obstruction. Empty pod bin

if needed.

Check/replace.

Check/replace.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Commentaires sur ces manuels

Pas de commentaire